Speedtech Floater 9" Ford User Manual download pdf

Page 1 of 12

May 13, 2014

Speedtech Chicane 9” Floater Rear Axle Assembly

This rear end assembly is the BEST axle for your Pro Touring car and here is why:

The Speed Tech Chicane 9” Floater incorporates the Corvette ZR1 rear drive hub and factory park

brake kit along with a NASCAR quality 9” housing with floating axles. The housing end is precision

CNC machined from Billet steel to ensure the highest strength possible. The ZR1 drive hub uses a

forged housing and dual bearing packs with 31 splines. This is a fully sealed unit that eliminates

the possibility of any contamination getting inside, it also incorporates the ZR1 Active wheel speed

sensor. This feature allows the addition of Anti-Lock Brakes and Traction Control. Another benefit

is that there is no regular maintenance required like all other floater assemblies that require

bearing cleaning and preload adjustment. This is one of the only Floater assemblies on the market

that incorporates a parking brake which is mandatory for LEGAL street operation.

1 2 3 4 5 6 ... 11 12

Page 1 of 12 May 13, 2014 Speedtech Chicane 9” Floater Rear Axle Assembly This rear end assembly is the BEST axle for your Pro Touring car and here

Page 10 of 12 Speedtech Performance USA LLC 435-628-4300 www.speedtechperformance.com Copyright Speedtech Perform

Page 11 of 12 Terms and Conditions of Sale 1. Effective January, 2008, supersedes all previous policy statements. Policies are subject to change wit

Page 12 of 12 This page is intentionally left blank.

Page 2 of 12 The following instructions are intended for professional installers and are guidelines only. Speedtech Performance assumes NO responsib

Page 3 of 12 1. Clean and prep housing for paint or powder coating if it has not already been done so. Once the housing is coated you can proceed

Page 4 of 12 3. Remove the parking brake bracket from the backing plate. Reinstall the park brake mounting bracket using the long spacers between

Page 5 of 12 5. Install the backing plate using the park brake mounting bolts to hold it in place DO NOT TIGHTEN THE BOLTS. **Note backing plate # B

Page 6 of 12 6. Unpin the ABS plug on the hub, this can be done with a paperclip by sliding it between the plastic housing and the retaining clip.

Page 7 of 12 Use a small amount of Silicone to seal the 2 wire slots as well as around the wires. This will keep any contaminants out of the hub. Re

Page 8 of 12 9. Once the third member is installed you can install the axles. You MUST use a GOOD quality bearing grease on the seal as well as the

Page 9 of 12 10. The axle retaining cap will be the last thing that needs to be installed, using some BLUE Loctite on all the bolts will help ensur

No comments

Speedtech Floater 9" Ford User Manual